The IP address 192.168.1.254 could be your default private IP address for some home broadband routers along with broadband modems.
Common routers or modems which use this IP include 2 wire, Aztech, Billion, Motorola, Netopia, SparkLAN, Thomson, Mediacom, along with Westell modems for CenturyLink.
About Private IP Addresses
192.168.1.254 is a private IP address, one of a block of addresses reserved for private networks. Which means a device within this private network cannot be accessed straight from the internet using this private ip address, however any device on a local network can connect with almost any other device also on this network.
As the router itself gets got the private ip address of all 192.168.1.254, it assigns some devices in its network that a different, private IP address. Each of IP addresses on a network should have a unique address within the network in order to avoid ip address address conflicts. Other common private IP addresses used by modems and routers would be 192.168.1.100, 192.168.1.101 or 192.168.100.1
Accessing the Router’s Admin Panel
The manufacturer sets a router’s IP address at the factory, however, you can change it at any given time using its administrative interface. Entering http://192.168.1.254 (not www.192.168.1.254) into a web browser address bar provides access for your router’s console, where you can change the router’s IP address in addition to configure a lot of other options.
In case you don’t know your router’s IP address, you can find it using a command prompt:
- Press Windows-X to open up the Power Users menu.
- In the event that you don’t see Command Prompt in the Power User Menu, then your computer may be configured instead of show Windows PowerShell. If that is the situation, type cmd in the search bar and then select Command Prompt from the search results which appear. Then jump to Step 3 below.
- Click Command Prompt (or type cmd in the search bar then click Command Prompt).
- Enter ipconfig to display an inventory of your computer’s connections.
- Find Default Gateway below the LAN (Local Area Network) section.
- Your active network connection might not be LAN Connection (Local Area Network). In the event that you don’t see in your ipconfig results, scroll through what really did show up and look for just about any connection having a Default Gateway.
- The IP address you see is your router’s IP address.
Default Usernames and Passwords
All routers have been shipped with default usernames and passwords. Even the user/pass combinations are quite standard for each manufacturer. These are almost always characterized by a decal on the hardware itself.
After you have access to your router’s administrative console, you can configure the router in many ways. Make sure to set a secure username/password combination. Without this, anyone can access your router’s board and then change its own settings without your knowledge.
Routers usually allow users to change the default settings, including the IP addresses they assign to devices on the network.